B
Menu and Memory Keys
B.1 Introduction
This appendix is a quick reference to the menus that can be accessed through the MENU and MEMory
keys. The number in parenthesis after the key is the number of times the key must be pressed to reach the
designated menu. MENU (1) means to press the key one time; MENU (2) means to press the key two
times, etc.
The key display information in this appendix is duplicated on the laminated Quick Reference card
shipped with the manual. The opposite side of the card contains a Summary of Commands described in
Appendix A.
Two levels of menu displays are available. The first level includes menus for normal 8500A functions.
The second level are the menus used during 1018B emulation. MENU (8) in the normal mode enables or
toggles the 1018B Emulation mode.
B.2 MENU Key Displays
B.2.1 Normal 8500A Functions
Keystrokes Menu Displayed
MENU (1) Menu = NEXT MENU
F1 set Int Trig and Level
F2 set Extrn Trigger
F3 to Cal or Zero Detectors
MENU (2) Menu = NEXT MENU; Minus = PREV MENU
F1 to Enter CW Averaging Number
F2 to Enter Peak Averaging Number
F3 for GPIB Plot
MENU (3) Menu = NEXT MENU; Minus = PREV MENU
F1 to Enter Detector A Offset
F2 to Enter Detector B Offset
F3 to Enter Source of Frequency Correction
NOTE: F2 does not apply to the Model 8501A
Manual No. 20790, Rev C, November 1998
B-1
To Next Page
