- 54 -
& VIA USB3.0 Controller (VIA VL800 USB Controller, USB 3.0/2.0 ports on the back
panel)
Enables or disables the VIA VL800 USB 3.0/2.0 controller. (Default: Enabled)
& Realtek LAN Controller (Realtek GbE LAN Chip, LAN2)
Enables or disables the Realtek GbE LAN function. (Default: Enabled)
If you wish to install a 3rd party add-in network card instead of using the onboard LAN, set this item to
Disabled.
` Marvell ATA Controller Conguration
& GSATA Controller (Marvell 88SE9172 Chip, eSATA connectors)
Enables or disables RAID for the SATA controllers integrated in the Marvell 88SE9172 chip or congures
the SATA controllers to AHCI mode. The area below displays the current status of the two SATA ports.
IDE Mode Disables RAID for the SATA controllers and congures the SATA controllers to IDE
mode.
AHCI Mode Congures the SATA controllers to AHCI mode. Advanced Host Controller Interface
(AHCI) is an interface specication that allows the storage driver to enable advanced
Serial ATA features such as Native Command Queuing and hot plug. (Default)
RAID Mode Enables RAID for the SATA controllers.
Disabled Disables this function.
To Next Page
Loading...
Need help?
General
