& SAS Controller (Intel C606 Chipset)
Enables or disables the integrated SAS controllers. (Default: Disabled)
& Audio Device Control
Enables or disables the onboard audio function. (Default: Enabled)
If you wish to install a 3rd party add-in audio card instead of using the onboard audio, set this item to
Disabled.
& USB 2.0 Controller
Enables or disables the integrated USB 2.0/1.1 controller. (Default: Enabled)
& Intel SATA Controller Mode (Intel C606 Chipset)
Enables or disables RAID for the SATA controllers integrated in the Intel C606 Chipset or congures the
SATA controllers to AHCI mode.
IDE Mode Disables RAID for the SATA controllers and congures the SATA controllers to IDE
mode.
RAID Mode Enables RAID for the SATA controllers.
AHCI Mode Congures the SATA controllers to AHCI mode. Advanced Host Controller Interface
(AHCI) is an interface specication that allows the storage driver to enable advanced
Serial ATA features such as Native Command Queuing and hot plug. (Default)
Disabled Disables this function.
& Port 0~5 Hot Plug
Enables or disables the hot plug function for the SATA3 0~1 and SATA2 2~5 connectors. (Default: Disabled)
& Legacy USB Support
Allows USB keyboard/mouse to be used in MS-DOS. (Default: Enabled)
& XHCI Hand-off
Determines whether to enable XHCI Hand-off feature for an operating system without XHCI Hand-off
support. (Default: Enabled)
& EHCI Hand-off
Determines whether to enable EHCI Hand-off feature for an operating system without EHCI Hand-off
support. (Default: Disabled)
& Port 60/64 Emulation
Enables or disables emulation of I/O ports 64h and 60h. This should be enabled for full legacy support
for USB keyboards/mice in MS-DOS or in operating system that does not natively support USB devices.
(Default: Disabled)
& USB Storage Devices
Displays a list of connected USB mass storage devices. This item appears only when a USB storage device
is installed.
` Trusted Computing
& TPM SUPPORT
Enables or disables Trusted Platform Module (TPM). Set this item to Enable when a TPM device is installed.
(Default: Disable)
& Fresco USB3.0 Controller (Fresco FL1009 USB Controller, USB 3.0/2.0 ports)
Enables or disables the Fresco FL1009 USB 3.0/2.0 controller. (Default: Enabled)