BIOS Setup
- 116 -
Parameter
Description
RCC_DEV0
ACS Rcc_Dev0
– Options available: Auto, Disable, Enable. Default setting is Auto.
AER Rcc_Dev0
– Options available: Auto, Disable, Enable. Default setting is Auto.
DlfEnableStrap1
– Options available: Auto, Disable, Enable. Default setting is Auto.
Phy16GTStrap1
– Options available: Auto, Disable, Enable. Default setting is Auto.
MarginEnStrap1
– Options available: Auto, Disable, Enable. Default setting is Auto.
SourceValStrap5
– Options available: Auto, Disable, Enable. Default setting is Auto.
TranslationalBlockingStrap5
– Options available: Auto, Disable, Enable. Default setting is Auto.
P2pReq ACS Control
– Options available: Auto, Disable, Enable. Default setting is Auto.
P2pCompStrap5
– Options available: Auto, Disable, Enable. Default setting is Auto.
UpstreamFwdStrap5
– Options available: Auto, Disable, Enable. Default setting is Auto.
P2PEgressStrap5
– Options available: Auto, Disable, Enable. Default setting is Auto.
DirectTranslatedStrap5
– Options available: Auto, Disable, Enable. Default setting is Auto.
SsidEnStrap5
– Options available: Auto, Disable, Enable. Default setting is Auto.
PriEnPageReq
– Options available: Auto, Disable, Enable. Default setting is Auto.
PriResetPageReq
– Options available: Auto, Disable, Enable. Default setting is Auto.
SourceVal ACS cntl
– Options available: Auto, Disable, Enable. Default setting is Auto.
TranslationalBlocking ACS Control
– Options available: Auto, Disable, Enable. Default setting is Auto.
P2pComp ACS Control
– Options available: Auto, Disable, Enable. Default setting is Auto.
UpstreamFwd ACS Control
– Options available: Auto, Disable, Enable. Default setting is Auto.
P2PEgress ACS Control
– Options available: Auto, Disable, Enable. Default setting is Auto.
P2pReqStrap5
– Options available: Auto, Disable, Enable. Default setting is Auto.
E2E_PREFIX
– Options available: Auto, Disable, Enable. Default setting is Auto.
To Next Page
Loading...
Need help?
General
