50
Setting the base
Gigaset E310/E310A (Panther) / MEA EN / A31008-M2301-A601-1-UZ19 / T-NetBox-registration.fm /
Version 5, 03.04.2011
Repeater support
You can increase the range and sig-
nal strength of the base using a
repeater. You will need to activate
repeater mode. This will terminate
any calls that are in progress at the
time.
§Menu§ ¤ q Settings ¤ §OK§
¤ q System ¤ §OK§
¤ q Repeater Mode
¤
§OK§ (‰ =activated)
After activating or deactivating the
repeater, switch your handset off
and on again (¢ page 20).
Protecting against
unauthorised access
Protect the system settings of the
base with a system PIN known only
to you. You will need to enter the
system PIN when, for example, regis-
tering/de-registering a handset to/
from the base.
Changing the system PIN
You can change the base's 4-digit
default system PIN ("0000") to a 4-
digit PIN known only to yourself.
Gigaset E310A: Setting a system PIN
enables remote operation of the
answering machine (¢ page 39).
§Menu§ ¤ q Settings ¤ §OK§
¤ q System ¤ §OK§
¤ q System PIN ¤ §OK§
¤ System PIN:
~ (Enter current system PIN) ¤
§OK§
¤ New PIN:
~ (Enter new system PIN) ¤
§OK§
Resetting the system PIN
If you have forgotten your system
PIN, you can reset the PIN to the
original code 0000 using the but-
ton on the base. This will also reset
other settings; see the section enti-
tled "Resetting the base to the
default settings".
Resetting the base to the
default settings
When restoring default settings:
u Individual settings are reset
u All lists are deleted
u Eco Mode and Eco Mode+ are
deactivated
The date and time are retained.
Please note
u Eco Mode / Eco Mode+
(¢ page 41) and repeater sup-
port cancel each other out, i.e.,
if you use a repeater, you can-
not use Eco Mode or Eco
Mode+.
u The default encrypted trans-
mission setting is deactivated
when repeater mode is acti-
vated.
Please note
The answering machine is ready
for use approx. 15 seconds after
the base has been connected or
reset.
To Next Page
Loading...
