Gigaset E310 - Operating the Base on the PABX

51
Operating the base on the PABX
Gigaset E310/E310A (Panther) / MEA EN / A31008-M2301-A601-1-UZ19 / T-NetBox-registration.fm /
Version 5, 03.04.2011
Resetting the base via the menu
When resetting via the menu
u Handsets are still registered
u The system PIN is not reset.
§Menu§ ¤ q Settings ¤ §OK§
¤ q System ¤ §OK§
¤ q Base Reset ¤ §OK§
¤ Reset to factory settings? ¤ §OK§
Resetting the base using the
button on the base
When resetting the base using the
button on the base
u All handsets are de-registered
and
u The system PIN is reset to the orig-
inal code 0000
Proceed as follows:
¤ Remove the mains cable from the
base.
¤ Hold down the registration/pag-
ing key ù on the base (¢ page 2)
while reconnecting the power
cable to the base. Hold the key
down for at least 5 seconds.
Operating the base on
the PABX
The following settings are only nec-
essary if your PABX requires them;
see the PABX user manual.
Changing the dialling mode
§Menu§ ¤ P#Q5#11
¤ Enter the digit for the dialling
mode: Q = tone dialling (DTMF);
1 =pulse dialling (PD) ¤
§OK .
Temporarily switching to
tone dialling (DTMF)
If your PABX still operates with pulse
dialling (PD), but you need tone dial-
ling for a connection (e.g., to listen
to the network mailbox), you must
switch to tone dialling for the call.
Prerequisite: You are conducting a
call or have already dialled an exter-
nal number.
¤ Press the star key P.
Tone dialling is now activated for
this call only.
Setting recall
§Menu§ ¤ P#Q5#12
¤ Enter digits for recall:
Q =80ms; 1 = 100 ms;
2 = 120 ms; I = 400 ms;
4 = 250 ms; 5 = 300 ms;
L = 600 ms; M = 800 ms ¤
§OK .
Please note
All handsets are de-registered
and must be re-registered. All set-
tings are reset to the default set-
tings.