Page 90 MDE-5412C Passport® EDGE Installation and Start-up Manual · February 2019
Appendix E: Moving a Snapshot Backup from the PX52/PX60 System
10 Remove USB drive from the Passport PX52/PX60 system server.
11 Select Shutdown from System Maintenance.
Figure 129: System Maintenance - Shutdown
12
Verify that the Passport Server is completely shut down, remove PX52/60 hardware, cables,
monitor, etc.
Note: All peripherals will be reused.
13 Install the new PS65 hardware that has been either, preloaded from the Gilbarco factory with
Passport V11.02 or pre-staged from the factory location.
14 Power ON the server PS65 system.
To Next Page
Loading...
Need help?
General