03_05
03_06
Sparkplugdismantlement (03_05, 03_06)
Remove one of the two foot-rest side fairings by loosening the four fixing screws un-
derneath the passenger's foot peg.
Detach the spark plug screened cap and remove the spark plug using the box-spanner
provided.
Upon refitting, screw the spark plug back in by hand, with the correct inclination; use
the box-spanner for tightening only. Refit the cap with care.
Upon refitting, pay attention to insert the foot peg through the hole in the fairing, then
tighten the four screws by hand.
CAUTION
FOLLOW THESE PROCEDURES VERY CAREFULLY TO AVOID ANY SEVERE
DAMAGE THAT MAY BE CAUSED BY THE VERY POWERFUL IGNITION SYS-
TEM.
CAUTION
THE SPARK PLUG MUST BE REMOVED WHEN THE ENGINE IS COLD.
USING IGNITION ELECTRONIC CENTRAL UNITS OR SPARK PLUGS OTHER
THAN THE TYPES PRESCRIBED (SEE «TECHNICAL DATA» SECTION) CAN
CAUSE SERIOUS DAMAGE TO THE ENGINE.
Characteristic
Spark plug
CHAMPION RN3C
electrode gap
0.45 ÷ 0.55 mm
34
To Next Page
Loading...
