EasyManua.ls Logo

Gilera Runner 50 SP 2012 - Tyre Puncture and Storage Preparation

Gilera Runner 50 SP 2012
72 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
ERAL TIMES IN ORDER TO ALLOW THE PADS TO SETTLE AND THE LEVER
STROKE TO BE SET TO THE CORRECT POSITION.
03_31
Puncture (03_31)
The vehicle is equipped with Tubeless tyres. When there is a puncture, Tubeless tyres
-unlike balloon tyres- go flat very slowly. This offers greater riding safety. A tyre that
goes flat very slowly can be repaired with an "INFLATE AND REPAIR" spray. Tyres
should be later fully repaired at an Authorised Piaggio-Gilera Service Centre.
03_32
delveicolo (03_32)
We recommend carrying out the following operations:
1. General cleaning of the vehicle.
2. With the engine off and the piston at the bottom dead centre position, remove the
spark plug, and pour 1-2 cm³ of recommended oil through its hole. Press the engine
start pedal 3 or 4 times letting the engine perform a few revolutions slowly, then replace
the spark plug.
3. Drain up all the vehicle fuel; spread antirust grease on the uncoated metal parts;
keep the wheels off the ground, by resting the chassis on two wooden wedges.
4. For the battery, follow the procedures described in the «Battery» section.
5. Drain the petrol from the carburettor float chamber through the bleed cap.
50
3 Maintenance

Related product manuals