Gilson pipetman - Page 16

- 16 -
 Charge your pipette by using stand adapter
(seeChapter2):
- First place the stand adapter on your Gilson
SINGLE pipette holder or CARROUSEL.
- Remove the plug. Now place your pipette
on the stand adapter and plug the power
transformer into the stand adapter.
- The pipette starts charging.
BatterychargingofPIPETMANMusing the
POWERCARROUSEL:
- First install the POWER CARROUSEL as
described above.
- Remove the plug. Now place your pipette
on the charging position, please ensure that
thepipetteisproperlyttedtothecontacts
ontthetopofthecarrousel(apropertting
will trigger a beep sound).
- The pipette starts charging.
Working with charger connected to the pipette
PIPETMAN M can also be used for pipetting while
charging.
- Plug the power supply into your pipette.
- Press the push-button to start your pipette.
- PIPETMAN M is ready to pipette.
 You can also recharge PIPETMAN M by USB with your com-
puter; however it will take much longer than by power supply.
Low Battery Warning:
PIPETMAN M has a low battery alert. As the battery runs down, the LOW
BATTERY message appears.The warning is replaced by a blinking symbol
of an empty battery. If it is not recharged, the pipette will switch o after a
while. Settings will not be lost.
If the battery is completely discharged (= black screen, no operation) please connect the pipette to
thechargerforatleastveminutes,thena“batt.toolow”messagewillappear.Thepipettewilldisplay
the last settings used a few minutes later and will continue charging.
Changing the battery
If the following symptoms occur, please contact
your Gilson Service Center for battery change:
Never work with PIPETMAN M while
charging by computer!
PIPETMAN M uses Lithium-Ion battery.
Operation on the battery is done at
user’s risk only. Opening the pipette
voids the warranty!
Use only the original power
transformer supplied by Gilson. Use
of an incompatible power supply can
damage your PIPETMAN M!