Gilson pipetman - 2 PARTS CHECK LIST AND ACCESSORIES; 3 GETTING STARTED

- 4 -
2 PARTS CHECK LIST AND ACCESSORIES
Contents:
Just take a moment to verify that the following
items are present:
• PIPETMAN M pipette,
• PowerSupply5VwithACadapterandcable,
• 4BatteryTags,
• 4EjectorTags,
• Tipejectorextension(P10Mmodelonly),
• User’sGuide,
• QuickGuide,
• Safetybag,
• Certicateofconformity(includingbar-code
sticker),
• Lubricant(exceptforP10M,P8x20M,P12x20M,
P8x200M,P12x200M,P8x300M,P12x300M)).
3 GETTING STARTED
PIPETMAN Misprovidedwithaminimalbatterycharge.BeforeusingyournewPIPETMAN M, we strongly
recommend you to fully charge the battery. PIPETMANMcharges80%ofitsfullbatterycapacityin
less than an hour, it takes three hours to fully charge the battery. Please refer to PIPETMANM Power
Management(Chapter12)forchargingprocedure.
Switch on your PIPETMAN M:
Press the push-button to activate the pipette. The start-up screen appears:
Thepipettewilldoaselfcalibrationtest,thermwareresetsthepiston.
During initialization, displayed on the screen, you will see the volume
range,versionofrmwareandthenumberofreadjustments.
Your PIPETMAN M is preset on PIPET mode and isnowreadytopipette
(see Chapter 5).
PIPETMANM goesinto sleepmode after3minutesof inactivity.The
display will shut o. Just press the push-button to reactivate the pipette,
your last setting and pipetting mode will appear on the screen.
Accessories:
The following items are available separately:
• POWERCARROUSEL5-positionchargingcar-
rousel for single and multichannel models
FB1001
• BatteryTags(setof4)
 F807013
• EjectorTags(setof4)
 F807014
Please contact your Gilson Distributor for
theseaccessories.
Volume range
Version of
firmware
Number of readjustments