Gilson VALVEMATE - Operation

3-1
3
Operation
This section describes how to control the VALVEMATE. You can control the
VALVEMATE using the front panel, contact closures, or Gilson Serial Input/Output
Channel (GSIOC).
Note: If a Rheodyne 5000-series valve is installed in the VALVEMATE, check and if
necessary, tighten the screws located on the front of the valve before each run. These
screws may loosen over time causing fluid to leak.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com