by clicking the left key of mouse, or clicking directly on the waves to select it, which can select
to accept or reject heartbeat to analyze.
In this figure, the white wave denotes the wave is accepted, the gray wave denotes the wave is
On the right table, some statistical data will be displayed automatically.
Click "Auto-Check", you can set the percent higher or lower than average heart rate. The default
value is 10% (As Figure 95).
Click the "Time Domain Analysis" and "Frequency Domain Analysis" button to enter their
The small waves at the upper interface are superposition waves. You can adjust the position of
window by clicking the left key of mouse. The default is 20ms point after the end of QRS wave.
Frequency Domain Analysis is changed when the QRS ending point of the unfiltrated wave is
To Next Page
Loading...