Gima CONTEC 8000 - Chapter 4 Device Operation Precautions; 4.1 Precautions Before Operation; 4.2 Precautions During Use

1
2
Chapter 4 Device Operation Precautions
4.1 Precautions before use
4.1.1 For safe and effective use, please read the user manual carefully before operation.
4.1.2 Read the contents of installation and startup described in User Manual before installing, to
avoid equipment damage.
4.1.3 Make sure the installation condition meets requirements, otherwise the software may work
or display abnormally.
4.1.4 Check that the device is in good condition.
4.1.5 The device shall be placed on a flat surface, and moves gently to avoid strong vibration or
shock.
4.1.6 Check that the lead cables are correctly connected before starting.
4.1.7 Choose a location that is easily grounded in the room. Do not allow the patient and the
patient's wire to come into contact with other conductor parts, including the earth or a
well-grounded hospital bed.
4.1.8 Clean the lead wire Clean with a neutral solvent. Do not use alcohol-based cleaners or
germicides.
4.1.9 Ensure that the device is operating within the normal ambient temperature range of +5℃ to
+40℃. If the device is stored at a higher or lower temperature, keep it in the operating
environment for approximately 10 minutes before using it on order to ensure the normal work.
4.2 Precautions during operating
4
.2.1 During using, the doctor should observe the patient carefully without leaving the operation
site. If necessary, turn off the power or remove the electrode to ensure patient safety.