Double-click the figure show area of the Frontal plane (the Right Sagittal plane or Horizontal
plane), you can enter the amplified Frontal plane (the Right Sagittal plane or Horizontal plane)
You can select and set the format of the report to be printed at lower right area of the interface.
The "Report of Print vector total" includes three-vector rings and integrated data. You can also
select which vector and which vector ring will be printed in the "Print Select" region (P ring, Qrs
The percentage of QRS area which falls in II, III, IV or I phases are displayed in the edge of that
VCG parameters are as follows:
Max A (QRS) maximal amplitude of QRS loop (mV)
Max A (P) maximal amplitude of P loop (mV)
Max A (T) maximal amplitude of T loop (mV)
Angle (QRS) angle of the max QRS amplitude (degree)
Angle (T) angle of the max T amplitude (degree)
Angle (P) angle of the max P amplitude (degree)
Rotation (QRS) rotation direction of QRS loop
To Next Page
Loading...