EasyManuals Logo

GIRBAU LOGI CONTROL User Manual

GIRBAU LOGI CONTROL
81 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #16 background imageLoading...
Page #16 background image
Program execution mode 16
Cod. 523340
Rev. 10/1016
4.6. Using the dispenser
Fill the compartments with the corresponding products, according to these symbols:
Fig. 4.3 Fig. 4.4
Symbols used in the dispenser (Fig. 4.3, 4.4).
LOGI CONTROL
LOGI PRO CONTROL
Powdered detergent for pre-wash
Dispensing compartment 1 (powder)
Powdered detergent for wash
Dispensing compartment 2 (powder)
Liquid bleach (chlorine, bleach, etc.)
Dispensing compartment 3 (liquid)
Liquid softener / neutraliser
Dispensing compartment 4 (liquid)
IN ORDER TO OPERATE CORRECTLY AND TO PREVENT POSSIBLE DAMAGE AND SPLASHING, THE
DISPENSER DRAWER MUST ALWAYS REMAIN CLOSED, EXCEPT WHEN ADDING PRODUCTS.
SUDS CONTROL
The mechanical action of front-loading washing machines improves the quality of the wash but
encourages the creation of suds.
Remember that a suds bath always reduces the efficiency of your wash. ALWAYS USE CONTROLLED
SUDS DETERGENT.
Models with a capacity lower than 13 kg (30 lb) incorporate a group of programmes (SP-I) for a superior
rinse efficiency.
Oversudsing causes an increase in the pressure inside the machine and decreases the efficiency of the
sealing systems.
Repeated washing with a large amount of suds considerably reduces the life of seals and bearings.
THIS CIRCUMSTANCE IS NOT COVERED BY THE MACHINE’S WARRANTY.

Table of Contents

Other manuals for GIRBAU LOGI CONTROL

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the GIRBAU LOGI CONTROL and is the answer not in the manual?

GIRBAU LOGI CONTROL Specifications

General IconGeneral
BrandGIRBAU
ModelLOGI CONTROL
CategoryController
LanguageEnglish

Related product manuals