GIRBAU LOGI CONTROL - Program Modification Sequence

LOGI PRO. Advanced mode 63
Cod. 523340
Rev. 10/1016
8.5.3. Program modification sequence
Access the ADVANCED USE MODE (Section 8.2). The display shows Pro.
Press the key to access the PROGRAMMING menu.
The display shows Pr-1. Program 1 is ready for modification. The ▲/▼ keys allow the user to select another
program. Press the key to access the modification of the displayed program.
The display shows Pr-1. Phase 1 is ready for modification. The ▲/▼ keys allow the user to select another
phase. Press the key to start modifying the values of the selected phase.
When the number of the phase is displayed (at the start of phase), the START/STOP key is used to finalise the
program modification.
Once a program modification has been finalised, the display will show the Pr-* report (modified program).
Pressing the START/STOP key allows the user to access the higher level of the menu. Pressing twice
consecutively allows the user to exit the ADVANCED USE MODE.
Activation of the phase
Allows the user to program the execution of the selected phase.
Once the desired phase to be modified has been selected, press the key. The display shows Ph-*.
OPTIONS
MEANING
Ph-Y
The phase to be executed is available
Ph-N
The phase to be executed is unavailable
The ▲key allows the user to modify the option displayed.
The key validates the selection on the display and allows the user to access the following programmable
function.
Bath level
Bath level allows the selection of the bath level inside the washer.
OPTIONS
MEANING
L-0
Without water inlet
L-1
Low level
L-2
Medium low level
L-3
Medium level
L-4
Medium high level
L-5
High level
L-6
Extra high level
The ▲/▼ keys allow the user to modify the option displayed.
The key validates the selection on the display and allows the user to access the following programmable
function.
CAUTION!
Programming levels L4, L5 and L6 IS NOT ALLOWED in models with a pump drain or drain closed
without power supply.