Close the door of the washing machine. The door report on the display will change to Pr-* (last executed
program).If Pr does not appear on the display, repeat the door closing operation).
Select the desired program with the program selection keys. The selected program number will be shown on
the display. (To find out the initial content of each program, see Section 7.3.: Content of the washing
programs).
Place the washing products in the dispenser and close it.
Pressing the key will cause the LOAd report to be shown on the display. The load selection LEDs
light up.
The / keys allow the user to modify the machine's load selection. The load selection LEDs switch on
or off depending on the load selected. (This option can be disabled in the Mod menu (see Section 8.7).
Press the key again to confirm the load selected and start the washing program.
Door lock. After giving the start order, a 30-second security time is started during which the drum rotation
and the water inlet operate at short impulses and door remains released. At the end of this time, the locking
mechanism closes and the wash cycle begins.
While the program is running, and depending on the configuration of parameter dt in the Mod, menu, the
display will show the various functions being executed by the washing machine or the time remaining for the
program (see Section 8.7)
Once the program has finished, the door will remain locked until End appears on the display.
Once the program has finished, the load selection returns to the maximum value.
DOOR FITTED WITH SAFETY LOCK
Never attempt to open the door if:
the program has not finished.
the drum has not come to a complete halt.
the bath has not been completely evacuated.
To Next Page
Loading...
Need help?
General
