GIRBAU LOGI CONTROL - Page 21

Program execution mode 21
Cod. 523340
Rev. 10/1016
LOGI PRO CONTROL
Sequence of parameters that can be consulted and how they are shown on the display:
The parameters that can be consulted vary slightly depending on the dt parameter selected in the Mod menu
(Section 8.7).
dt-0
dt-1
consultable parameter
display
consultable parameter
display
program running
P-**
program running
P-**
remaining program time
t-**
phase running (see Note 1)
Ph**
Bath temperature
C-**
Bath temperature
C-**
percentage of water
consumption and dosing used
%-**
percentage of water
consumption and dosing used
%-**
Note 1. The numbering of the phase running refers to the program tables in Section 8.4.
The parameters can be consulted by pressing the key successively while the program is running.