GIRBAU LOGI CONTROL User Manual

LOGI PRO. Advanced mode 70
Cod. 523340
Rev. 10/1016
Proportional water level
This modifies the values of the bath levels in proportion to the predetermined load.
OPTIONS
MEANING
JL-0
Proportional modification of the bath time deactivated
JL-1
Proportional modification of the bath time activated
The ▲ key allows the user to modify the option displayed.
The key validates the selection on the display and allows the user to access the following programmable
function.
Proportional dosing time
This option only appears if JL-1 has been programmed in the previous stage.
It modifies the dosing time in proportion to the bath level calculated according to the predetermined load.
OPTIONS
MEANING
dL-0
Proportional modification of the dosing time deactivated
dL-1
Proportional modification of the dosing time activated
The ▲ key allows the user to modify the option displayed.
The key validates the selection on the display and allows the user to access the following programmable
function.
Hot water purge
The purge is an option that keeps the water inlet valve and the drain valve simultaneously open during the
programmed time, with the aim of purging the hot water pipe.
The purge function is only executed during the first phase of the program with water filling if the programmed
temperature is equal or higher than 86 ºF (30 ºC).
Purge time: programmable in 5 second steps.
OPTIONS
MEANING
Pg-0
Purge disabled
Pg**
Programmed purge time. Maximum time: 250 sec.
The ▲/▼ keys allows to activate and modify the purge time.
The key validates the selection on the display and allows the user to access the following programmable
function.
Network identifier
This parameter assigns a network identifier to the washer. This identifier enables the communication of the
washer with the environment through a protocol based on RS-485.
Selected option by default: Id-0.
OPTIONS
MEANING
Id-0
Disabled communication
Id-1..99
Enabled communication
For further information, see the Communication Protocol Instruction Manual.
The ▲/▼ keys allows to activate and modify the Network identifier.
Press the key. The display shows Mod.
The ▲/▼ keys allow the user to access to other menus.
To exit the ADVANCED USE MODE press the START/STOP key.

GIRBAU LOGI CONTROL Specifications

General

Brand	GIRBAU
Model	LOGI CONTROL
Category	Controller
Language	English