Page 11
ALWAYS operate slicer with knife cover, sharpener, and knife ring guard securely in place.
Failure to do so will cause serious personal injury.
MANUAL SLICER OPERATION
NOTE: For Manual Operation with an Automatic Slicer, please proceed to page 13 of this manual.
1. With slicer turned off, pull food chute completely towards you and place food product onto the food chute.
Slice only boneless, unfrozen product with slicer. (Models 3600NF and 3975NF are recommended for
slicing frozen product.) Use end weight to hold food product in place. If the end weight is not needed,
it can be stored out of the way by swinging it back behind food chute and locking it on retaining pin.
2. Make sure all knobs are tightened prior to using slicer.
3. Rotate slice thickness dial counterclockwise to desired setting. If you happen to go past desired setting, you
must rst rotate slice thickness dial clockwise past zero (0), and then rotate dial back to desired slice thickness
setting. After slicing is complete, always turn slice thickness dial clockwise past zero (0) until it stops to close
slicer table.
4. Turn slicer on by pushing START button on front of slicer. Power indicator light will illuminate.
DO NOT hold food product with your hand. Never put your hand on or around food chute when
slicer is on. Food chute handle is the only part of slicer you should touch while slicing.
5. Use food chute handle to manually push food chute back and forth. The food chute handle is the only slicer
part you should touch while slicing. Do not catch slices with your hand. Let slices drop onto receiving area.
If a product needs to be adjusted during slicing, ALWAYS pull food chute all the way towards you.
Turn off slicer and close slicer table prior to adjusting product and end weight.
6. After last slice stroke, pull food chute all the way towards you. Turn slicer off by pressing STOP button located
on the front of slicer. The power indicator light will go out. Always turn slice thickness dial clockwise past
zero (0) until it stops to close slicer table.
7. Now you can load and unload food product from food chute.
Operating Instructions
To Next Page
Loading...
Need help?
General
