GLOW T180 - Page 83

CONTRACTOR NAME:
READING
I confirm that the information listed on this commissioning sheet is a true and accurate account of what has been completed.
POSTAL CODE:
CITY:
FAX:
ADDRESS:
CELL:
DATE:
POSTAL CODE:
EMAIL:
BUILDER/SITE NAME:
HOMEOWNER NAME:
Ensure the installation manual is left with the appliance
209 Citation Drive, Concord Ontario L4K 2Y8. Tel: 905-264-1414, Fax: 905-264-1147
Email: info@glowbrand.ca Website: www.glowbrand.ca
Inspect and verify the safety components are operating as intended
Verify the outlet water temperature is set to 120°F / 49°C
Ensure the pressure relief is installed and operating properly
Ensure a minimum 24" clearance from the appliance front is maintained
Technician:
Model #:
ADDRESS:
CITY:
Bleed all the air from the heating loop / recirculation line if equipped
Ensure the drain tube and condensate hose are properly installed
Verify that the unit being installed matches the work order
PROCEDURE
Check that the condensate trap has been primed and is not obstructed
ADDITIONAL COMMENTS
Serial #:
INSTALLATION DATE:
MM/DD/YEAR
OTH:
TEL:
Prior to commencing any commissioning, Hydro, Gas and Water must be available at the Glow T180 unit
REMARKS
BLK / LOT #
TEL:
Check the Glow T180's CO₂ % complies with
values listed in the installation manual
NATUAL GAS, (CO₂%)
LIQUID PROPANE (CO₂%)
Check that there is no flammable material or liquids in the immediate vicinity of the appliance
WATER HEATER COMMISSIONING SHEET
Ensure the venting complies with the installation manual & local codes
Check for correct voltage & polarity
Verify that all gas and water connections are tight and leak free
Check the gas pressure at the appliance (min. 3.5" wc Nat / 8" wc Lp)
CELL:
TECHNICIAN SIGNATURE: