German Light Products GmbH JDC1
User Manual Rev. 1.0 5
stop using strobe effects. Help the person sit in a safe place or lay them on their
side with their head supported to prevent it from hitting the floor. Do not use
force. Seek emergency medical help if the seizure lasts for more than a few
minutes.
Do not operate a fixture with damaged, cracked, or missing pieces. All optical
components and covers must be in good condition.
1.3 NOTICE! Prevent Damage to Product or other Property
Avoid pointing the front of the fixture towards direct
sunlight or other strong light sources. The front lens
focuses and concentrates light just like a magnifying
glass. Direct sunlight and other bright light sources can
cause internal damage to the fixture, melting components or starting an internal
fire within seconds.
Damage can occur whether the fixture is powered on or off. To avoid problems:
Never expose the front of a fixture to direct sunlight or any other strong light
sources.
For outdoor applications during daylight, make sure that the front face of any
fixture is shielded or points away from the sun, even when not in use.
Avoid pointing other high-powered beam lights directly at the fixture.
Ensure that the head can rotate through its full tilt range before powering up the
fixture, and that fans and air vents are clean and unobstructed.
Use only original spare parts. Any structural modification on the system will
terminate all warranty claims.
To Next Page
Loading...
