14
THE THREE MEASURING MODES
This meter provides you with three modes for measuring; General,
AC, and PC. You can switch between each mode by:
1. Start with the meter switched off. Insert a test strip to turn on the
meter. The screen will display a flashing “ ” and “Gen”.
2. Press M to switch between General, AC, and PC modes.
Congratulations! You have completed all settings!
NOTE:
• These parameters can ONLY be changed in the setting mode.
• If the meter is idle for 3 minutes during the setting mode, it will switch
off automatically.
6. Setting the backlight
The default setting for meter backlight ("8L") is set to ON. Press M to
switch between “On” and “OFF”.Press S.
To Next Page
Loading...
