22
METER MEMORY
This meter stores the 1000 most recent blood glucose test results
along with respective HCT values, dates and times or β-ketone test
results along with respective dates and times in its memory. To enter
the meter memory, start with the meter switched off.
Reviewing Test Results
1. Press and release M.
“
” will appear on the display. Press M again, and the first reading
you see is the last blood glucose result along with HCT value, date,
time and the measuring mode or you will see the last β-ketone result
along with date, time and the measuring mode.
2. Press M to recall the test results stored in the meter. After the last
glucose or β-ketone test result, press M again and the meter will
switch off.
Reviewing Blood Glucose Day Average Results
1. Press and release M. When “
” appears on the display, keep
pressing M for 3 seconds until the flashing “ ” appears. Release
M and then your 7-day average result measured in general mode will
appear on the display.
2. Press M to review 14-, 21-, 28-, 60- and 90- day average results
stored in each measuring mode in the order of Gen, AC, then PC.
3. Exit the meter memory. Keep pressing the M and the meter will
switch off after displaying the last test result.
NOTE:
• Any time you wish to exit the memory, keep pressing M for 5 seconds or
leave it without any action for 3 minutes. The meter will switch off
automatically.
• Control test results are NOT included in the day average.
To Next Page
Loading...
