A PTO is a gearbox or mechanical device used to
transmit mechanical power from the powertrain,
through gears or a transmission, to another
mechanical or hydraulic device. Before using a
PTO, refer to the manufacturer’s or installer’s
instructions.
Parking
{CAUTION:
If you do not park your vehicle properly,
it can roll. If you have left the engine
running, it can move very quickly. You or
others could be injured. To be sure your
vehicle will not move, even when you are
on level ground, follow the steps below.
Parking a Vehicle With the Two-Speed
Rear Axle
1. With the engine running, shift the two-speed
rear axle into low. To be sure it is in low, you
will need to move the vehicle in gear just a little.
2. Hold the regular brake pedal down with your
right foot.
3. Apply the parking brake. See Parking Brake
(With Hydraulic Brakes) on page 81 or
Parking Brake (With Air Brakes) on page 82
for parking brake apply procedure.
4. Shift the transmission to NEUTRAL for
manual transmission or PARK (P) for
automatic transmission.
80
To Next Page
Loading...
Need help?
General
