POWER SOURCE: BATTERY POWER CABLE
Step Action Yes No
1
2
3
4
1. Unplug battery power cable power jack from DLC cable.
2. Using a digital multi-meter (DMM), verify voltage output at
battery power cable power jack.
Do you have battery voltage output?
Go to Step 2. Go to Step 3.
1. Remove DLC cable from Tech 2.
2. Plug in battery power cable power jack to the VCI power jack
connector located at bottom of Tech 2.
Does the Tech 2 power on?
Replace DLC cable. Problem with Tech 2.
Contact Customer
Support.
Using a DMM, verify voltage output at battery.
Do you have battery voltage output?
Go to Step 4. Charge battery.
Check fuse(s) in battery power cable (refer to Figure VI-24).
Does fuse(s) need replacing?
Replace fuse(s). Replace battery power
cable.
To Next Page
Loading...