SECTION III GETTING STARTED
2005 Tech 2 User’s Guide III - 5
Tech 2 Keypad
The Tech 2 keypad consists of six major keypad operation areas (Figure III-14):
1. Control keys (SHIFT, PWR)
2. Soft keys
3. Selection (arrow) keys
4. Action keys (YES, NO, ENTER, EXIT)
5. Function keys (F0 to F9)
6. Help (?) key
Control Keys
The [PWR] key is used to turn the Tech 2 on or off (Figure III-15). The status indicator light above this key
will be illuminated green when the Tech 2 is operational.
The [SHIFT] key is used with the up and down arrow keys to change screen brightness and contrast
(Figure III-15). To adjust screen brightness and contrast, perform the following:
• Press the [SHIFT] key once (amber status indicator light above [SHIFT] should light up).
• Use up and down arrows to adjust screen brightness and contrast:
Press up arrow key to increase screen brightness and contrast.
Press down arrow key to decrease screen brightness and contrast.
• Press [SHIFT] key again when desired brightness is reached (status indicator light above [SHIFT]
should now be off).
The Tech 2 should return to normal operation after following the above steps.
Figure III-14
Tech 2 keypad
Figure III-15
Location of control keys
To Next Page
Loading...