Signal Meter
The TX4800 may be programmed to display the strength
of the incoming signal on the right of the LCD. If that
section of the display is already being used, the signal
strength may appear briefly when the signal is first
received, then will return to the previous display.
NOTE: If required, the Signal meter can be programmed
to be 'dB linear'. In this case, the display shows the signal
strength directly in dB.
PROGRAMMABLE FUNCTIONS
Signal Meter
Function
-
F1 F2 F3 F4 F5 F6 CALL
Disabled
Transmit Hi/Lo Power
Monitor
Squelch
Talk-Around
Scan
OS/GS Toggle
Page (Transpond)
Quiet
Recall CH M1
Recall CH M2
Recall CH M3
Recall CH M4
Speed Dial Selcall Memory
Recall CH M1 + Dial Selcall Mem.
Recall CH M2 + Dial Selcall Mem.
Recall CH M3 + Dial Selcall Mem.
Recall CH M4 + Dial Selcall Mem.
Speed Dial DTMF M1
Speed Dial DTMF M2
Speed Dial DTMF M3
Function
-
F1 F2 F3 F4 F5 F6 CALL
Speed Dial DTMF M4
Recall CH M1 + Dial DTMF M1
Recall CH M1 + Dial DTMF M2
Recall CH M1 + Dial DTMF M3
Recall CH M1 + Dial DTMF M4
Recall CH M2 + Dial DTMF M1
Recall CH M2 + Dial DTMF M2
Recall CH M2 + Dial DTMF M3
Recall CH M2 + Dial DTMF M4
Recall CH M3 + Dial DTMF M1
Recall CH M3 + Dial DTMF M2
Recall CH M3 + Dial DTMF M3
Recall CH M3 + Dial DTMF M4
Recall CH M4 + Dial DTMF M1
Recall CH M4 + Dial DTMF M2
Recall CH M4 + Dial DTMF M3
Recall CH M4 + Dial DTMF M4
Call
Monitor (Inverted)
Monitor (Toggle)
S-Meter (Toggle)
Tick the boxes that match the function keys on the radio with the
specific feature programmed by the Dealer.
To Next Page
Loading...
