Compressed air needs to be supplied into the laminator to activate the bursting roller and pressure on the laminating roller.
NOTE : It is recommended to place the air compressor at outside of the laminator.
If this would be in the LamiTable, this will bring a short lifespan by high heat.
NOTE A large amount of moisture (water) is produced from the compressor during its operation.
For dry filter, it is necessary to remove such moisture (water), at least, 1time per a day.
Connection for Air Compressor
Insert air hose in to the air
compressor
Connect the air hose to the laminator
Plug in at Independent Power
System
To Next Page
Loading...
