GMP PROTOPIC III-540 - Sleeking Gloss and Matt Finish; Gloss;Matt Sleeking Setup and Foils

SLEEKING (GLOSS & MATT FINISH)
With GMP GLOSS SLEEKING FOIL & MATT SLEEKING FOIL, the surface of Toner Based Prints / Digital Prints can be
changed for higher quality of results.
Conditions for GLOSS/MATT SLEEKING FOILS
Model
Speed Set Temp.(℃) Pressure (MPa)
Protopic-series
3 110 0.5
(Table 1.1) (Picture 1.1)
How to load the Foils
(Picture 1.2)
NOTE : To have various sleeking effect of whole page/spot/hologram, etc.,
the sleeking bar is required.
How to install the sleeking bar, please refer to the "Main Device".
1.GLOSS/MATT SLEEKING
PROTOPIC III- 540
SLEEKING IDLE BAR
38/48