GMP PROTOPIC III-540 - Sleeking Hologram Finish; Hologram Sleeking Setup and Foils

SLEEKING(HOLOGRAM FINISH)
With GMP Hologram SLEEKING FOIL, the surface of Toner Based Prints / Digital Prints can be changed for higher quality of results.
Conditions for HOLOGRAM SLEEKING FOIL HOLOGRAM SLEEKING FOILS
Model
Speed Set Temp.(℃) Pressure (MPa)
① SPARKLE-HOLOGRAM
PROTOPIC II Series
3 105 0.5
② HIPER PLAID-HOLOGRAM
③ CRYSTAL-HOLOGRAM
(Table 2.1)
④ MILKY WAY-HOLOGRAM
⑤ STAR-HOLOGRAM
⑥ SPECTRUM-HOLOGRAM
⑦ MOSAIC-HOLOGRAM (Picture 2.1)
How to load the Foils
(Picture 2.2)
NOTE : To have various sleeking effect of whole page/spot/hologram, etc.,
the sleeking bar is required.
How to install the sleeking bar, please refer to the "Main Device".
1.HOLOGRAM SLEEKING
PROTOPIC III- 540
SLEEKING IDLE BAR
42/48