☞ Cooling Device for Embossing Roller [PROTOPIC III-540 DUAL PHOTO]
To keep the temp. on Photo Embossing Roller stable with cooling
for continuous quality of photo embossing during the job.
If photo embossing roller temp. would be higher than 35℃ , the cooler is automatically operated.
The lower cooling device is operated automatically while machine is operated
☞ Decurler
It is natural thing to have the curled laminated results after lamination.
This is not caused by the trouble in the Laminator.
Decurling Device is to avoid the Curling on the Laminated Results after single side lamination.
Adjust the Decurling Status with the Handle as the Pictures.
Rotate the Handle to the Right to increase the Decurling Value and rotate it to the left to decrease it.
Curling Way for Left Direction Rotating of Handle
Curling Way for Right Direction Rotating of Handle
NOTE : Adjust the Decurler Angle for Substrates Thickness and its Materials.
Decurler
Decurler Knob
Pull Roller
Pull Roller
Decurler
Decurler
Upper Cooling Device Lower Cooling Device
To Next Page
Loading...
