Gnet G-ON3 - Trouble Shooting; No Power (no Boot); Video Input Error

77
Check whether the power is applied even after starting the car-> Check the normal
operation (Setting → Power management → Check the power off voltage) → The
power was cut off by operating LBP.
1.
Unplug the power jack and plug it back in → If it is normal after inserting
the jack again → If the problem persists afterwards, send the problem
DASHCAM to GNET.
2.
If the main body power LED is turned on → off, if the chip managing power
→ only the power LED is turned on and DASHCAM is not working normally,
send the problem DASHCAM to GNET.
3.
No power (no boot)
After checking whether the front camera or the rear camera is due to a bad image
sensor, send the DASHCAM in question to GNET.
1.
Video input error
TROUBLE SHOOTING
TROUBLE SHOOTING