Gnet G-ON3 - 3-Wire Power Cable; 2-Wire Power Cable

5
Connect the power cable to the fuse box terminal inside the vehicle.
(The connected terminal should be one which is always supplied power even
when ACC power is turned off, such as emergency lights and/ or door racks.)
Otherwise if using a cigar power cable, plug it directly into the vehicle cigar
socket.
GNET strongly recommends having an experienced installer with the proper knowledge of electrical
systems install the device. Incorrectly wiring the power cable can result in damage to the vehicle or
the battery and can cause bodily injure.
CAUTION
6
Connect the other side of the power cable to the DC-IN labeled slot of the front
camera.
11
*3-wire power cable
Connect ACC to a fuse that does not flow when the vehicle is switched off
Connect VCC to current fuse at vehicle start-off
Connect GND to ground on the vehicle’s body
*2-wire power cable
Connect ACC and VCC to the terminal together, and change the setting from “3
wires” to “2 wires”.
INSTALLATI
ON
Rear cable [CAM1]
Interior cable [CAM2]
DC-IN
01. BEFORE USE