2020
6. Stop charging
The charging process is completed when the
LEDs light up green.
If you want to stop charging prematurely, use
the „cable release“ function of your vehicle or
the large round button of the go-e Charger app
(tab „Charging“).
The cable remains locked in the type 2 socket in
the standard setting after the charging process
has ended (adjustable via the app) until it is re-
moved from the vehicle (theft protection).
If the power supply is interrupted, the char-
ging cable remains locked in the charging box
for reasons of theft protection. To unlock it, it
is necessary to re-energise the charging station.
The cable can also be unlocked automatically
after a power failure, provided the function has
been activated in advance via the „Cable unlock“
setting in the app. However, it is then no longer
theft-protected in the event of a power failure.
The go-e Charger displays the charging status
via dierent colours and positions of the LEDs.
In addition, it executes a whole series of safe-
ty queries to check the used power source for
possible errors. For this reason, the go-e Char-
ger may display an error and refuse to charge,
especially with unknown power sources.
The device visualises the cause of the error by
certain colours and positions of the LEDs. You
can also nd the error message within the „Sta-
tus“ information of the app. (The following co-
lour codes correspond to the factory setting).
9. Commissioning/charging
10. LED status display/troublesho
otingoting
To Next Page
Loading...
Need help?
General
