go-e Gemini flex - RFID Chip Usage and Settings

2525
Reset to factory settings
You can also use the reset card to reset the
go-e Charger to factory settings:
• Hold the reset card in front of the chargers RFID
reader
• All LEDs light up red briey to conrm
The stored RFID chips and assigned consump-
tion data are not deleted during this process.
If you install the go-e Charger outdoors, you can
protect the device against use by unauthorised
persons by means of an RFID chip. In the settings
of the go-e Charger app, „Authentication
required“ or „RFID/App required“ needs to be
selected for this.
The delivered RFID chip is already learned.
To authenticate a person authorised for
charging, the chip needs to be held in front of
the RFID reader (below the logo of the charger)
before each charging process. Alternatively,
authentication can be done by tapping the
round button of the tab „Charging“ of the go-e
Charger app.
11. Reset card/RFID chip
Consumption overview for several users
Furthermore, additional user accounts can be
created with additional RFID chips (available
as accessories). This is useful if several people
share the unit and the charged current should
be displayed separately for each user in the app.
Additional RFID chips can be learned via the app
(„Settings“/“RFID chips“). Simply select one of
the free slots and follow the instructions in the
app. The chips can be renamed individually in
the app.
Any RFID chip/card that transmits on a frequency
of 13.56 MHz (e.g. also many credit cards) can
be learned.
Protection against unauthorised charging
RFID chip