go-e Gemini flex - Electrical Protective Measures

77
4. Safety regulations/notes
Any information regarding electrical in-
stallation is intended exclusively for a
qualied electrician whose training all-
ows all electrical work to be carried out
in accordance with the applicable natio-
nal regulations.
Before carrying out electrical connec-
tion work, you need to de-energise the
circuit.
Installation must be carried out in accor-
dance with local, regional and national
regulations.
Observe the permissible ambient condi-
tions from the data sheet.
A location without direct sunlight is re-
commended.
The Charger is only suitable for charging
gassing vehicle traction batteries in well-
ventilated rooms.
The unit must not be operated indoors
if there is an increased danger from am-
monia gases.
The Charger should not be operated in
the immediate vicinity of ammable or
explosive substances, running water or
heat-emitting equipment.
Electrical protective measures, installation, operation
High voltage - danger to life! Never use
the go-e Charger if the housing is dama-
ged or open.
In case of unusual heat development, do
not touch the go-e Charger, the charging
cable or adapter and stop the charging
process as soon as possible. If the plastic
is discoloured or deformed, contact cus-
tomer support.
Never cover the go-e Charger during
charging. Heat build-up can lead to re.
Persons wearing electronic implants
should keep at least 60 cm away from
the go-e Charger due to electromagnetic
elds.
Due to legal regulations the Gemini ex
Charger must not be used in the follo-
wing countries: Norway.
The go-e Charger Gemini ex has
the communication interfaces WiFi
802.11b/g/n 2.4GHz and RFID. WiFi is
operated on a frequency of 2.4Ghz,
channels 1-13 with the frequency band
2412-2472Mhz. The maximum transmis-
sion power of the WiFi is 20dBm. RFID
is operated on a frequency of 13.56MHz
with a maximum radiated power of
60dBμA/m at 10m.