go-e Gemini flex - Product Overview; Product Components Overview

99
Opening, conversions,
repair, maintenance
Registration/approval
obligation, legal information
Any modication or repair of the hard-
ware or software of a go-e Charger may
only be carried out by specialist person-
nel of go-e GmbH.
Before dismantling an allegedly defecti-
ve product, always contact go-e‘s tech-
nical customer support and wait for its
decision on the further procedure for
handling the service case.
Removing and damaging warning noti-
ces attached to the go-e Charger or ope-
ning the device will result in the loss of
any liability by go-e GmbH. The warranty
also expires in the event of any modica-
tion or opening of a go-e product.
The go-e Charger is maintenance-free.
Disposal
According to directive 2012/19/EU (WEEE
directive), electrical devices must not be
disposed of in household waste after the
end of use. Take the product in accor-
dance with national legal requirements
to a collection point specially set up for
waste electrical equipment. Also dispose
of the product packaging properly so
that it can be recycled.
Depending on the country, the require-
ments of the authorities and electricity
grid operators must be observed, such
as the obligation to register or obtain
approval for ev charging stations or the
limitation of single-phase charging. Con-
tact your grid operator/electricity provi-
der to nd out whether the go-e Charger
requires registration or approval (e.g. in
Germany) and whether other limitations
must be observed.
The copyright for these operating inst-
ructions is owned by go-e GmbH.
All texts and illustrations correspond to
the technical status at the time of writing.
go-e GmbH reserves the right to make
unannounced changes. The content of
the operating instructions does not jus-
tify any claims against the manufacturer.
Pictures are for illustration purposes and
may dier from the actual product.
charging currents. Therefore check the
country settings in the goe-e app before
using an adapter with domestic plug. If
a domestic socket overheats, reduce the
charging current.
Take care of a mechanical relief of the
domestic plug by supporting the weight
of the go-e Charger and the connected
charging cable!
Do not use go-e Charger if any cable
attached to or plugged into the unit is
damaged.
Never use wet or dirty plugs in connec-
tion with the go-e Charger.
Never pull plugs out of the connector by
the cable!
The device may be cleaned with a damp
cloth. Do not use cleaning agents or sol-
vents. Do not clean the device with a
high-pressure cleaner or under running
water.