9988
4. Safety regulations/notes4. Safety regulations/notes
the product packaging properly so that it can be recycled.
Registration/approval obligation, legal informationRegistration/approval obligation, legal information
Depending on the country, the requirements of the authorities and electricity grid operators must
be observed, such as the obligation to register or obtain approval for ev charging stations or
the limitation of single-phase charging. Contact your grid operator/electricity provider to nd out
whether the go-eCharger requires registration or approval (e.g. in Germany) and whether other
limitations must be observed.
The copyright for these operating instructions is owned by go-e GmbH.
All texts and illustrations correspond to the technical status at the time of writing. go-e GmbH
reserves the right to make unannounced changes. The content of the operating instructions does
not justify any claims against the manufacturer. Pictures are for illustration purposes and may
dier from the actual product.
5. Product overview 5. Product overview
Connection cable
direct connection to a junction box possible
RFID chip
Release of charging processes (can be activated via app)
Reset card
Required for using the app and for resetting the charger to
factory settings
Housing
Impact-resistant and UV-resistant high-performance plastic
RFID reader
Release of charging processes with RFID chips or cards
(can be activated via app)
Button
Change of charging strength (5 levels - adjustable via app)
LED ring
Display of charging strength (1 LED = 1 ampere)
and charging status
Rating plate
With serial number of the charger
Fine wire fuse
Protects the unit electronics in case of incorrectly con-
nected supply line
Sealed screw
Opening leads to loss of warranty
Type 2 socket
Anschluss für Typ 2 Stecker des Ladekabels
(mit Wetterschutz)
Back
To Next Page
Loading...
