go-e HOMEfix - Reset Card;Rfid Chip;Fine Wire Fuse; App

25252424
11. Reset card/RFID chip/Fine wire fuse11. Reset card/RFID chip/Fine wire fuse 11. Reset card/RFID chip/Fine wire fuse11. Reset card/RFID chip/Fine wire fuse
Fine wire fuseFine wire fuse
If the supply line is connected incorrectly, the ne-
wire fuse of the go-eCharger will trip in order to
protect the electronics of the unit.
In this case, you need to unscrew the fuse cap
(circular with the inscription „Fuse“) on the back of
the charger with a screwdriver, remove the melted
fuse, insert a replacement fuse and then reattach
the cap. The ne wire fuse is also allowed to be
changed by the user of the appliance himself.
Disconnect the charger from the power supply
beforehand. Only use original go-e ne wire fuses
(one included in the scope of delivery).
Reset to factory settings
You can also use the reset card to reset the
go-eCharger to factory settings:
• Hold the reset card in front of the chargers RFID reader
• All LEDs light up red briey to conrm
The stored RFID chips and assigned consumption
data are not deleted during this process.
go-eCharger reset cardgo-eCharger reset card
On the back of the reset card you will find important
access data which you need to set up the app
control of the charger:
• “Serial number“: Serial number of the go-eCharger
• “Hotspot SSID“: WiFi hotspot name of the charger
• “Hotspot key“: WiFi hotspot password of the device
• “QR-Code“: Automatically connection to the hotspot
RFID chipRFID chip
Protection against unauthorised charging
If you install the go-eCharger outdoors, you can
protect the device against use by unauthorised
persons by means of an RFID chip. In the settings
of the go-eCharger app, „Authentication required“
or „RFID/App required“ needs to be selected for
this.
The delivered RFID chip is already learned.
To authenticate a person authorised for charging,
the chip needs to be held in front of the RFID
reader before each charging process. Alternatively,
authentication can be done by tapping the round
button of the tab „Charging“ of the go-eCharger
app.
Ideally, leave the reset card at a secure location
where you can quickly access it in case you need
it.
Consumption overview for several users
Furthermore, additional user accounts can be
created with additional RFID chips (available
as accessories). This is useful if several people
share the unit and the charged current should be
displayed separately for each user in the app.
Additional RFID chips can be learned via the app
(„Settings“/“RFID chips“). Simply select one of the
free slots and follow the instructions in the app.
The chips can be renamed individually in the app.
Any RFID chip/card that transmits on a frequency
of 13.56 MHz (e.g. also many credit cards) can be
learned.