go-e HOMEfix - Technical Data

13131212
HOMEx
11 kW
HOMEx
22 kW
Remark
Single-phase
charging car¹
1.4 kW
to 3.7 kW
1.4 kW
to 7.4 kW
Country-specic limitations
need to be observed
Two-phase
charging car¹
2.8 kW
to 7.4 kW
2.8 kW
to 14.8 kW
Two-phase connection of the charger
is not possible
Three-phase
charging car¹
4.2 kW
to 11 kW
4.2 kW
to 22 kW
go-eCharger switches through the po-
wer that is available at the connection
¹Charging power depending on the number of phases of the car‘s onboard charger
Connection to vehicleConnection to vehicle
go-eCharger app and connectivitygo-eCharger app and connectivity
Safety functionsSafety functions
HOMEx 11 kW HOMEx 22 kW
Type 2 socket (acc. to IEC 62196-2) with mechanical locking device
(own type 2 cable required, available as accessory)
Vehicles with type 1 can be charged with adapter cable type 2 to type 1
(available as accessories)
HOMEx 11 kW HOMEx 22 kW
RCD protection module
with DC current detec-
tion
30 mA AC, 6 mA DC
Protection class I
Pollution degree II
Anti-theft device Charging cable locking device
RFID access control One learned RFID chip included
Input voltage Phase and voltage testing
Switching functions Testing of the switching functions
Ground check
For TT, TN grids
(deactivatable ground check for IT grid - Norway mode)
Current sensor 3-phase
Fine wire fuse
To protect the internal electronics
(triggers if the supply line is connected incorrectly)
IP54
Protected against dirt and water, suitable for permanent out-
door operation (IP 44 when charging cable is plugged)
go-e network operator
API
For authorised access by the electricity grid operator to the
go-eCharger for grid-serving power control
Modbus TCP
e.g. for grid-serving power control by the electricity grid opera-
tor (from rmware version 0.40)
HOMEx 11 kW HOMEx 22 kW
Local (WiFi hotspot) or worlwide* (WiFi) controlling and monitoring
Adjustment/check of the charge (voltage, current, power, energy)
Adjusting the current level in 1 ampere steps
Start/stop function
Management of RFID chips/cards (up to 10 users per charger)
Scheduler
Electricity meter (total kWh and total amount per RFID chip)
kWh limit mode
Access control (RFID/App)
Cable unlock functions
Electricity price exchange connection (aWATTar mode) with intelligent charging manage-
ment*/**
Static load balancing*
Photovoltaic connection via open API interface
(programming required)
LED adjustment
Management of the charging levels via button on the charging station
Updateable for later functions (Smart home, etc.)
Automatic unlocking of the charging cable in the event of a power failure***
1-/3-phase switching via app - even during the charging process***
Synchronisation of charging processes with the cloud and display of the past charging
processes***
Documented public API interfaces: HTTP , MQTT, Modbus TCP
*WiFi connection of the charger required
**Separate electricity supply contract with partner aWATTar required, currently only available in Austria and Germany
***from go-eCharger serial numbers with CM-03- (hardware version V3)
7. Technical data7. Technical data 7. Technical data7. Technical data