15151414
8. Installation8. Installation 8. Installation8. Installation
4.
Hook the go-eCharger into the wall bracket.
Optional: If required, attach the supplied U-piece
directly above the charger, making it impossible to
remove the device from the wall bracket. In addi-
tion, a padlock (not included in the scope of delive-
ry) can be attached.
1.
Mount the go-eCharger approx. 1.00 to 1.45 me-
ters above the ground, depending on your perso-
nal feeling of well-being.
Place the wall bracket in the desired mounting
position. Use a spirit level to align it straight. Mark
the four drill holes with a pencil by using the wall
bracket as a template.
4x
1 m - 1,45 m
2.
Drill holes at the four marked positions.
4x
3.
Attach the wall bracket with four screws and do-
wels each. Drive the dowels into the wall with a
hammer.
Make sure that the surface is not warped. The
device may not be attached if the wall bracket is
distorted. Compensate possible unevenness of
the wall with spacers (not included in the scope of
delivery).
4x
Benötigte WerkzeugeBenötigte Werkzeuge
a Pencil b Spirit level c Measuring tape d Drilling machine
e Screwdriver f Hammer g Cutter knife h Side cutter
i Dowel 8 x 40 mm j Screws for wall bracket 4.5 x 50 mm
k Screw for U-piece 4 x 50 mm
l U-piece (optional anti-theft device) m Wall bracket
Beiliegendes BefestigungsmaterialBeiliegendes Befestigungsmaterial
a
b
c
d
e
f
j
k l mi
5x 4x 1x
g h
To Next Page
Loading...
