27272626
12. App - connection setup12. App - connection setup 12. App - connection setup12. App - connection setup
The go-eCharger can also be used without an app.
Download the go-eCharger app if you want to
change basic settings, use comfort functions, read
the internal electricity meter or control the charger
remotely.
The go-eCharger app is available for download
on the platforms listed opposite, depending on the
operating system of your mobile device.
3.
6.
Set up connection via hotspotSet up connection via hotspot
1. Some smartphones require deactivating mo-
bile data and terminating active WiFi connec-
tions.
2. Either scan the QR code of the reset card
(an external app may be required for this) or
manually search for the charger‘s network (di-
splayed as go-e-xxxxxx) in the settings of your
mobile device to connect to the charger‘s hot-
spot. If you connect manually, you need to en-
ter the password that you will nd on the reset
card under „Hotspot key“.
3. Now launch the go-eCharger app.
4. If the „Charging“ page is already displayed,
you can already operate the charger locally via
the app. Otherwise, you need to select your
go-eCharger in the app beforehand.
Set up connection via WiFiSet up connection via WiFi
For remote control of the charger and for some
comfort functions, a WiFi connection of the char-
ger is essential.
1. To connect to the WiFi network, you have to
establish an active hotspot connection to the
Charger (as described above).
2. Then tap the blue „+“ icon in the app.
3. On the following screen, select „Initial setup
for new go-eCharger“. As soon as the hotspot
connection has been detected, tap on „Next“.
On the next screen, the connection to WiFi
needs to be activated.
4. Enter the name of your WiFi („SSID“) or se-
lect your WiFi (if displayed). You also need to
enter the „password“ of this WiFi network. As
soon as the connection has been established,
a „Next“ button appears, which you have to
tap. Follow the subsequent instructions of the
app until the „Done“ button appears. Tap this
button.
5. Check whether the connection to the go-e
Cloud is allowed under „Advanced settings“
(in the „Internet“ tab of the go-eCharger app).
6. Disconnect from the Charger‘s hotspot. Ac-
tivate your mobile data or connect to a WiFi
network. Tap the „+“ icon in the go-e Charger
app again. Select „Add an already set up go-
eCharger“. Now enter the serial number and
the password you assigned yourself (alternati-
vely, if available on the reset card, the „Cloud
token“). The Charger can then be controlled
remotely via mobile data or WiFi.
To Next Page
Loading...
