gpelectric.com | [page 21]
48. Clear Mid Voltage Alarm
When the mid-point voltage deviation falls below this value, the alarm is switched o. This value needs to be less
than or equal to the previous parameter.
Default Range Step Size
1.5% 0-99% 0.1%
5.2.4 DISPLAY SETTINGS
49. Black-light Intensity
The intensity of the back-light, ranging from 0 (always o) to 9 (maximum intensity).
Default Range Step Size
5 0-9 1
50. Black-light Always On
When set the back-light will not automatically turn o after 60 seconds of inactivity.
Default Range
OFF OFF/ON
51. Scroll Speed
The scroll speed of the display, ranging from 1 (very slow) to 5 (very fast).
Default Range Step Size
2 1-5 1
52. Main Voltage Display
Must be ON to display the voltage of the main battery in the monitoring menu.
53. Current Display
Must be ON to display current in the monitoring menu.
54. Power Display
Must be ON to display power in the monitoring menu.
55. Consumed Ah Display
Must be ON to display consumed Ah in the monitoring menu.
56. State of Charge Display
Must be ON to display state-of-charge in the monitoring menu.
57. Time to Go Display
Must be ON to display time-to-go in the monitoring menu.
FULL SET-UP DETAILS
To Next Page
Loading...
Need help?
General
