Godex EZ-2 - Command Description

13
4.2 Command description
Set up commands
The setup commands must be sent before the buffer mode commands or label formatting commands.
1. Esc Dn
Function : Set the print darkness level.
Parameter : n = 0 ~ 7 ( 5 is default value)
2. Esc In
Function : Select country code character Sets.
Parameter : n Country Code Character Set
0 US ASCII (8 bits) 256 characters
1 British (7 bits) 128 characters
2 German (7 bits) 128 characters
3 French (7 bits) 128 characters
4 Italian (7 bits) 128 characters
5 Danish (7 bits) 128 characters
6 Spanish (7 bits) 128 characters
7 Swedish (7 bits) 128 characters
8 Swiss (7 bits) 128 characters
3. Esc ?n
Function : Select Bar code type.
Parameter : n Format
1 Code 128B/C
2 Interleaved 2 of 5
3 Code 39 (default)
9 Code 93
K Codabar
U UPC A/E, UPC A/E + add on 2/5 (for EZ-4)
E EAN 8/13, EAN 8/13 + add on 2/5 (for EZ-4)
4. Esc Mnn
Function : Left Margin.
Parameter : nn = 01~99 millimeters (default value is 03 mm)
5. Esc Nnn
Function : Setting form feed length for plain paper.
Parameter : nn = 01~25 millimeters
6. Esc On
Function : Extra Feed. (Set printer EZ-2S/EZ-4S on peeler mode)
Parameter : If gap = 2 mm If gap = 3 mm
n = 1 8 mm n = 1 7 mm
n = 2 7 mm n = 2 6 mm
n = 3 6 mm n = 3 5 mm
n = 4 5 mm n = 4 4 mm
n = 5 4 mm n = 5 3 mm
n = 6 3 mm n = 6 2 mm
n = 7 2 mm n = 7 1 mm
This command must follow Esc Qnnn or Esc qnnn.
7. Esc ON
Function : Disable peeler mode. (EZ-2S/ EZ-4S)
PDF created with FinePrint pdfFactory trial version http://www.fineprint.com