Godex RT700 SERIES Service Manual

18
Step 2. Assemble the see-through sensor
Put the see-through sensor (red circle 1) into the TPH cover and engage it with latches (red circle 2&3)
on both sides of TPH cover.
Step 5. Assemble the TPH cover
Engage the latches of the cover into the bracket as the figure below indicates
Step 6. Assemble the TPH module
Assemble the TPH module as the figure below indicates
front
back

Godex RT700 SERIES Specifications

General

Print Method	Thermal Transfer / Direct Thermal
Print Resolution	203 dpi
Memory	8 MB Flash, 16 MB SDRAM
Max Print Speed	5 ips
Max Print Length	1727 mm (68")
Processor	32-bit RISC
Interface	USB, Serial, Ethernet
Media Type	Continuous, Die-cut, Fan-fold
Media Width	25.4 mm - 118 mm (1" - 4.64")
Media Thickness	0.06 mm - 0.25 mm
Media Roll Diameter	127 mm (5")
Ribbon Width	30 mm - 110 mm (1.18" - 4.33")
Power	100-240V AC, 50/60Hz
Dimensions	285 mm (L) x 210 mm (W) x 171 mm (H)
Operating Temperature	41°F to 104°F (5°C to 40°C)
Storage Temperature	-4°F to 122°F (-20°C to 50°C)