Godox V1S - TTL Autoflash Mode; TTL Mode Operation Details; FEC: Flash Exposure Compensation

14
Flash Mode—TTL AutoFlash
This flash has three flash modes: TTL, Manual (M), and Multi (Stroboscopic). In TTL mode,
the camera and the flash will work together to calculate the correct exposure for the
subject and the background. In this mode, multiple TTL functions are available: FEC, HSS,
second curtain sync, modeling flash, control with the camera’s menu screen.
*Press <MODE> Mode Selection Button and three flash modes will display on the LCD
panel one by one with each pressing.
TTL Mode
Press <MODE> Mode Selection Button to enter TTL mode. The mode LCD panel will
display.
• Press the camera release button halfway to focus. The aperture and effective
flash range will be displayed in the viewfinder.
• When the shutter button is fully pressed, the flash will fire pre-flash that the
camera will use to calculate exposure and flash output the instant before the
photo is taken.
FEC: Flash Exposure Compensation
With FEC function, this flash can adjust from -3 to +3 in 1/3 stops. It is useful in situations
where minor adjusting of the TTL system is needed based on the environment.
FEC Setting:
Press Function Button 2
Press the <+/-> button. The
icon < > and flash
exposure compensation
amount will be highlighted
on the LCD panel.
Set the flash exposure
compensation amount.
• Turn the Select Dial
to set the amount.
• “0.3” means 1/3
step, “0.7” means
2/3 step.
• To cancel the flash
exposure
compensation, set
the amount to “+0”.
Press Set Button again to
confirm the setting.