Godox V1S - Other Flash Applications; Sync Triggering via Cord; Auto Focus Assist Beam Function; Bounce Flash Technique Explained

26
Multi: Wireless Flash Shooting with Manual Flash
1. Setting <MULTI> Stroboscopic flash
• Press <MODE> button so that <MULTI> is displayed.
• Setting the stroboscopic flash.
Other Applications
Sync Triggering
The Sync Cord Jack is a Φ2.5mm plug. Insert a trigger plug here and the flash will be fired
synchronously with the camera shutter.
Auto Focus Assist Beam
In poorly-lit or low contrast shooting environments, the built-in auto focus assist beam
will automatically light on to make it easier for the autofocus. The beam will light up only
when autofocus is difficult and get out as soon as the autofocus becomes correct.
If you want to turn off the auto focus assist beam, set the “AF” to “OFF” on the C.Fn
settings.
• If you find he auto assist beam does not light up, this is because the camera has
got a correct autofocus.
• Camera models that support auto focus assist beam: 7M3/ 7R3/ 7II/ 7/
6000/ 9
Position
Effective Range
Center
0.6~10m / 2.0~32.8 feet
Periphery
0.6~5m / 2.0~16.4 feet
Bounce Flash
By pointing the flash head toward a wall or ceiling, the flash will bounce off the surface
before illuminating the subject. This can soften shadows behind the subject for a more
natural-looking shot.
This is called bounce flash.
To set the bounce direction, hold the flash head and turn it to a satisfying angle.