Godox V1S - TTL Automatic Wireless Flash Setup; Transmitter Unit Setup Steps; Receiver Unit Setup Steps; Checking Wireless Flash Operation

23
TTL: Fully Automatic Wireless Flash Shooting
Using Automatic Wireless Flash with a Single Receiver Unit
Transmitter Unit Setting
• Attach a V1S camera flash on the camera and set it as the Transmitter unit.
• M/A/B/C can be set to TTL separately.
Receiver Unit Setting
• Set the other camera flash as the wireless Receiver Unit
Check the communication channel.
• If the Transmitter unit Receiver unit(s) are set to a different channel, set them to
the same channel.
Position the camera and flashes
• Position the camera and flashes as the picture shows.
Check that the flash is ready
• Check that the Transmitter flash ready indicator is lightened.
Check the flash operation.
• Press the Transmitter unit’s Test Button < >
• Then, the Receiver unit will fire. If not, adjust the Receiver unit’s angle toward the
Transmitter unit and distance from the Transmitter unit